Products

NX9 – Rib Feature

In NX, you can use the Rib command to add a thin-wall rib or rib network to a solid body by extruding an intersecting planar section.

In this video, Ashley Eckhoff describes some of the enhancements in NX9 to the Rib Feature.


 Don’t forget to subscribe to the NX Design Forum, so that you will get notification of new blog posts in your email.

Jerry

Jerry Sarfati

Leave a Reply

This article first appeared on the Siemens Digital Industries Software blog at https://blogs.stage.sw.siemens.com/nx-design/nx9-rib-feature/